Docker Community Forums

Share and learn in the Docker community.

How to check if enough resources are present before spawning docker contaner

Hello everyone, i have a python program which gives me the option of running any of the docker images installed on my computer.I have a question is that before that python program spawns the next container,is there any where i can know that enough resources are present are present before starting it.

–memory-swap is a modifier flag that only has meaning if --memory is also set. Using swap allows the container to write excess memory requirements to disk when the container has exhausted all the RAM that is available to it. There is a performance penalty for applications that swap memory to disk often.

Its setting can have complicated effects:

If --memory-swap is set to a positive integer, then both --memory and --memory-swap must be set. --memory-swap represents the total amount of memory and swap that can be used, and --memory controls the amount used by non-swap memory. So if --memory=“300m” and --memory-swap=“1g”, the container can use 300m of memory and 700m (1g - 300m) swap.

If --memory-swap is set to 0, the setting is ignored, and the value is treated as unset.

If --memory-swap is set to the same value as --memory, and --memory is set to a positive integer, the container does not have access to swap. See Prevent a container from using swap.

If --memory-swap is unset, and --memory is set, the container can use as much swap as the --memory setting, if the host container has swap memory configured. For instance, if --memory=“300m” and --memory-swap is not set, the container can use 600m in total of memory and swap.

If --memory-swap is explicitly set to -1, the container is allowed to use unlimited swap, up to the amount available on the host system.

Inside the container, tools like free report the host’s available swap, not what’s available inside the container. Don’t rely on the output of free or similar tools to determine whether swap is present.

If --memory and --memory-swap are set to the same value, this prevents containers from using any swap. This is because --memory-swap is the amount of combined memory and swap that can be used, while --memory is only the amount of physical memory that can be used.

–memory-swappiness details
A value of 0 turns off anonymous page swapping.
A value of 100 sets all anonymous pages as swappable.
By default, if you do not set --memory-swappiness, the value is inherited from the host machine.
–kernel-memory details
Kernel memory limits are expressed in terms of the overall memory allocated to a container. Consider the following scenarios:

Unlimited memory, unlimited kernel memory: This is the default behavior.
Unlimited memory, limited kernel memory: This is appropriate when the amount of memory needed by all cgroups is greater than the amount of memory that actually exists on the host machine. You can configure the kernel memory to never go over what is available on the host machine, and containers which need more memory need to wait for it.
Limited memory, unlimited kernel memory: The overall memory is limited, but the kernel memory is not.
Limited memory, limited kernel memory: Limiting both user and kernel memory can be useful for debugging memory-related problems. If a container is using an unexpected amount of either type of memory, it runs out of memory without affecting other containers or the host machine. Within this setting, if the kernel memory limit is lower than the user memory limit, running out of kernel memory causes the container to experience an OOM error. If the kernel memory limit is higher than the user memory limit, the kernel limit does not cause the container to experience an OOM.
When you turn on any kernel memory limits, the host machine tracks “high water mark” statistics on a per-process basis, so you can track which processes (in this case, containers) are using excess memory. This can be seen per process by viewing /proc//status on the host machine.